Fix release date: 10 June 2019
Status: Current



Ticket#Update Details
1589, 1663, 1664Three VoIP parameters were added to the parameter group in BVR and can be found under Configuration->System Configuration->VoIP SIP Signalling:
  • Put call on hold before REFER - added ability to control whether or not call is put on hold prior to transferring using SIP.
  • Include Retry-After in Additional Responses - added option for ability to prevent BVR from always setting the Retry-After header in non-2xx INVITE responses.
  • Inbound SIP OPTIONS detection threshold - added option for ability to set a maximum amount of time BVR can go without receiving an out of dialog OPTIONS message.

1669Fixed an issue with the bvr_lsi executeable writing spurious error messages during deviation of an AIX system ID similar to the following:


entstat: 0909-003 Unable to connect to device ent0, errno = 19


1672Fixed a rare race condition that could cause VOIPL3_SIP to core in certain circumstances.
N/AFixed an issue in the vae.setuser script that would incorrectly report that the DB2 installed is at a lower level than the required level to support BVR 7 for AIX.


Download information


The Fix Update for this issue is available on the Blueworx FTP site:


https://blueworx.hostedftp.com/files/path/Fix+Center/BVR700AIX/BVR.7.0.0.10.tar.Z


The Fix Update also might require requisites Fix Update files to be installed and are available on our Blueworx FTP site.